Manualshelf

User Manual for Powe Burner Diamond Series

ManualsBrandsFire Magic ManualsBarbecue19 Inch Built-In Side Burner with 3,000 - 60,000 BTU, Double Ring Cast Brass Burner and Back-Lit Control Knobs: Stainless Steel Grid, Liquid Propane
11121314151617181920
17
Fig. 17-1 Connect power burner to power supply
A
B
Power burner
Power burner
wire harness extension
Power supply
box
C
To install using a power supply box (not included):
1. Install the power supply box at least 12 inches below the
bottom of the power burner.
2. Fasten the power supply box to the inside of the enclosure.
3. Connect the power supply box connectors to the power
burner wire harness extension, as shown in Fig. 17-1, A
(molex and ground wire connections).
4. Connect the power burner wire harness extension to the
power burner, as shown in Fig. 17-1, B (molex and ground
wire connections).
5. Connect the cord coming from the power supply
box to a 120VAC (15 AMP minimum) GFCI
GROUNDED 3-wire receptacle. See Fig. 17-1,
C and 17-2 .
WARNING: Electrical Grounding Instructions - The
power supply box is equipped with a three-
pronged (grounding) plug for your protection
against shock hazard and should be plugged
directly into a properly grounded three-
prong receptacle. Do not cut or remove the
grounding prong from this plug.
INSTALLATION (cont.)
Fig. 17-2 Electrical setup detail
3-wire GROUNDED
cord from unit
120VAC (15 AMP minimum) GFCI
GROUNDED 3-wire receptacle