User Manual for Powe Burner Diamond Series

SLIDE UNIT INTO ENCLOSURE

Slide the unit into place. Do not to pinch, kink, or

damage the gas connector line.

Note: Each side of the unit has a tab just behind

the control panel. These tabs prevent the

control panel from moving inward. If the

tabs interfere with the unit sliding in (see

Fig. 19-1), use pliers to bend them inward

so that they clear the enclosure sides.

Leave the tabs slightly out to ensure they

still keep the control panel from moving

inward (see Fig. 19-2).

INSTALL THE FLAME COLLIMATOR

1. Place the ﬂ ame collimator over the burner with the tabs

and cutouts resting on the inner liner shelf, as shown

in Fig. 19-3. Flex the front of the collimator towards the

burner until the cut outs ﬁ t down around the collimator

support. This will lock your collimator into place. The

ﬂ ame collimator acts as a barrier for windy conditions

and creates higher BTU concentration in the cooking

grid.

2. When using a wok for stir fry cooking, remove the grid

and the wok will be supported by the collimator.

Cut

outs

Fig. 19-3 Placing the ﬂ ame collimator

Flame

Collimator

Collimator support

T abs

Fig. 19-1 Tab may interfere when sliding in unit

Fig. 19-2 Tab slightly bent in for clearance

INSTALLATION (cont.)