User Manual for Powe Burner Diamond Series

21
SHUTTING OFF THE UNIT
To shut off the unit, depress each valve control knob
and while pressing turn it clockwise to the OFF position.
Always close the valve from the gas supply after each
use of the unit.
ELECTRONIC LIGHTING
Note: Electronic lighting requires an installed 9-volt
battery with a good charge.
1. Open lid(s) or remove cover(s) from burner(s) to be lit.
2. Turn all gas control knob(s) to their OFF position(s).
3. Turn on the gas at its source.
Note: DO NOT
turn on more
than one valve at
a time for either
electronic or
manual lighting.
4. Depress the desired control knob for 5 seconds,
then, while pressing turn it counterclockwise to the
HI LIGHT position. Once the burner lights, release
the knob.
CAUTION: If a burner does not light within fi ve (5)
seconds of turning on the control knob,
depress the knob and turn it to the OFF
position. WAIT FIVE (5) MINUTES
before repeating step 4. If you smell
gas, follow the instructions on the cover
of this manual. If the burners still do not
light after several attempts, refer to the
instructions for manual lighting.
5. Repeat step 4 for each additional burner to be lit.
WHEN USING A PORTABLE PROPANE TANK
Propane tanks are equipped with a safety shutdown
device that may cause low or no gas pressure/fl ame
at the burners if operating and lighting instructions
are not followed exactly (See important note in the
TROUBLESHOOTING section for more details.)
MANUAL LIGHTING
CAUTION: Always wait fi ve (5) minutes for gas to
clear after any unsuccessful lighting
attempt.
1. Follow steps 1 through 3 (left).
2. Insert either a burning long-barrel butane lighter or
a burning long-stem match through the cooking grid
opening to the top of the lighting tube. (Fig. 21-2).
For backburners, hold the flame
against the surface of the backburner.
For sideburners, hold the fl ame against the burner.
3. Hold the match / lighter fl ame at the top of the lighting
tube for 5 seconds, or, next to the sideburner /
backburner. Then depress the appropriate control
knob and while pressing turn it counterclockwise to
the HI LIGHT position. Remove the lighter or match
when the burner lights, and release the control knob.
4. If the burner does not light within fi ve (5) seconds
of turning the control knob, immediately depress
the knob and turn the valve to OFF. WAIT FIVE
(5) MINUTES before repeating steps 2 through 4 of
the MANUAL LIGHTING instructions.
Read all instructions before lighting, and follow these instructions each time you light the unit.
Fig. 21-2 - Manual lighting
Lighter
Lighting
tube
3. Hold the match / lighter fl ame at the top of the lighting
tube for 5 seconds, or, next to the backburner. Then
depress the appropriate control knob and while
pressing turn it counterclockwise to the HI LIGHT
position. Remove the lighter or match when the
burner lights, and release the control knob.
CAUTION: Always wait fi ve minutes for gas to clear
after any unsuccessful lighting attempt.
WARNING: DO NOT put hand directly above the burner
when lighting but off to the side as shown
(Fig. 21-2).
1. Follow steps 1 through 3 (left).
2a. Insert either a burning long-barrel butane lighter, a
burning long-stem match, or a burning match held by
a wire extension holder through the cooking grids to
the desired burner to be lit (Fig.
21-2). With the fl ame
still next to the burner, depress the corresponding
control knob (outer burner- right knob, inner burner-
left knob), and while pressing turn it counterclockwise
to the HI LIGHT position. Remove the lighter or match
when the burner lights, and release the control knob.
2b. To manually light the second burner, after step 2a
has been followed, depress the corresponding control
knob, and while pressing turn it counterclockwise to the
HI LIGHT position. The second burner will light from the
fl ame of the already lit burner. Release the control knob.
3. If the burner does not light within fi ve (5) seconds
of turning the control knob, IMMEDIATELY turn the
burner control knob to the OFF position. WAIT FIVE
MINUTES before repeating steps 2 and 3 of the
MANUAL LIGHTING INSTRUCTIONS.
Outer
Burner
Control
Fig. 21-2 - Manual lighting
Outer
Burner
Control
Fig. 21-2 - Manual lighting
Note: This unit must be connected to 120VAC power
for electronic lighting.
Fig. 21-1 - Control knob
OFF
HI
LIGHT
LOW
TO
TURN OFF
TO TURN ON
Read setting
here
HIGH to
LIGHT
Read setting here
(OFF position shown)
To Turn OFF
To Turn ON
Use
HI (high)
to light
Press
knob in
to turn
Gas Flow
Indicator
For your convenience and safety; when the
control knob is in the on position, the gas fl ow
indicator will change from blue to red. (Red
indicates gas fl ow.) See Fig. 21-1.
LIGHTING (IGNITION) INSTRUCTIONS
USE
,
CARE
,
&
SERVICE