User Manual for Powe Burner Diamond Series

3
L-C2-333
REV 3 - 1601181405
INSTALLATION
INSTALLATION ........................................................ 15
COUNTER PREPARATION ..................................... 15
CONNECT THE GAS SUPPLY ................................. 15
CONNECT TO A POWER SOURCE .......................... 16
POWER SUPPLY (MULTIPLE ACCESSORY UNITS) ... 18
SLIDE UNIT INTO ENCLOSURE ............................. 19
INSTALL THE FLAME COLLIMATOR ....................... 19
USE, CARE, & SERVICE
LIGHTING (IGNITION) INSTRUCTIONS .................. 21
ELECTRONIC LIGHTING ...................................... 21
MANUAL LIGHTING ............................................. 21
SHUTTING OFF THE UNIT .................................... 21
CARE & CLEANING ................................................. 22
CONVERT GAS TYPE / CHECK BURNER ORIFICES 23
AIR SHUTTER ADJUSTMENT .................................. 25
CONTROL PANEL REMOVAL .................................. 26
TROUBLESHOOTING ............................................... 27
WARRANTY ............................................................. 28
CONTENTS
GETTING
STARTED
To protect against electric shock, do not immerse cord or plugs (if equipped) in water or other liquid.
Unplug from the outlet (if applicable) when not in use and before cleaning. Allow to cool before putting
on or taking off parts.
Do not operate any outdoor cooking gas appliance with a damaged cord, plug, or after the appliance
malfunctions or has been damaged in any manner. Contact the manufacturer for repair.
Do not let the cord hang over the edge of a table or touch hot surfaces.
Do not use an outdoor cooking gas appliance for purposes other than intended.
When connecting, fi rst connect plug to the outdoor cooking gas appliance then plug appliance into the outlet.
Use only a properly wired and inspected 120VAC (15 AMP minimum) GFCI GROUNDED 3-wire receptacle
with this outdoor cooking gas appliance.
Never remove the grounding plug or use with an adapter of 2 prongs.
Use only extension cords with a 3 prong grounding plug, rated for the power of the equipment, and
approved for outdoor use with a W-A marking.
GETTING STARTED
ELECTRICAL SAFETY ...............................................3
POWER BURNER PARTS LIST ...................................4
MODEL SPECIFICATIONS ..........................................5
Model Specifi cations Table ........................................5
COUNTERTOP OVERHANG .....................................5
RECOMMENDED OFFSET INSTALL .........................6
SUBSTRATE ...........................................................6
POWER BURNER DIMENSIONS TABLE .....................7
POWER BURNER WIRING DIAGRAM ........................7
MAINTENANCE AND SAFETY INFORMATON ..........8
ELECTRICAL CONNECTIONS ..................................8
LIGHT SWITCH ......................................................8
INSTALLATION REQUIREMENTS .............................9
EXHAUST REMOVAL ........................................... 10
ENSURE PROPER COMBUSTION AIR AND
COOLING AIRFLOW
............................................ 10
GAS-SUPPLY PLUMBING REQUIREMENTS ............ 10
ENCLOSURE REQUIREMENTS ................................11
VENTILATION (ALL ENCLOSURES) ........................11
WHEN A PROPANE (L.P.) CYLINDER IS USED IN
THE ENCLOSURE
................................................11
PROPANE SAFETY INFORMATION ........................ 12
WARNING .......................................................... 12
INSTALLATION SAFETY GUIDELINES.................... 12
OPERATING THE UNIT SAFELY AND
CORRECTLY ............................................................ 12
SAFE USE & MAINTENANCE OF
PROPANE GAS CYLINDERS ................................... 13
ELECTRICAL SAFETY