Installation and Operating Instructions

11
MANUAL LIGHTING
CAUTION: Always wait fi ve minutes for gas to clear
after any unsuccessful lighting attempt.
WARNING: DO NOT put hand directly above the
burner when lighting but off to the side as
shown (Fig. 11-3).
1. Follow steps 1 through 3 (left).
2a. Insert either a burning long-barrel butane lighter, a
burning long-stem match, or a burning match held
by a wire extension holder (Fig.
11-2) through the
cooking grids to the desired burner to be lit (Fig. 11-3).
With the fl ame still next to the burner, depress the
corresponding control knob (outer burner- right
knob, inner burner- left knob), and while pressing
turn it counterclockwise to the HI LIGHT position.
Remove the lighter or match when the burner lights,
and release the control knob.
2b. To manually light the second burner, after step 2a
has been followed, depress the corresponding control
knob, and while pressing turn it counterclockwise to
the HI LIGHT position. The second burner will light
from the fl ame of the already lit burner. Release the
control knob.
3. If the burner does not light, IMMEDIATELY turn the
burner control knob to the OFF position. WAIT FIVE
MINUTES before repeating steps 2 and 3 of the
MANUAL LIGHTING INSTRUCTIONS.
ELECTRONIC LIGHTING
1. Remove the cover.
2. Turn all gas control knobs to their OFF positions.
3. Turn on the gas at its source.
Note: No matter which lighting method you use, DO
NOT light more than one burner at a time.
4. Depress the desired control knob, and while pressing
turn it counterclockwise to the HI LIGHT position.
Once the burner lights, release the control knob.
CAUTION: If a burner does not light within five
seconds, turn the control knob back to
the OFF position. WAIT FIVE MINUTES
before repeating step 4. If you smell gas,
follow the instructions on the cover of this
manual. If the burners still do not light after
several attempts, refer to the instructions
for MANUAL LIGHTING.
FOR PROPANE ONLY
Propane tanks are equipped with a safety shutdown
device that may cause low or no gas pressure/fl ame
at the burners if operating and lighting instructions
are not followed exactly (See important note in the
TROUBLESHOOTING section for more details.)
ADJUSTING THE FLAME
The knobs on the control panel of the power burner
control the valves and adjust the fl ame height. The fi rst
labeled position is OFF, the second HI LIGHT, and the
third LOW. In between the HI LIGHT and LOW labels
are midpoint marks. Flame height can be set anywhere
between the HI LIGHT and LOW settings.
The height of the fl ame with a valve in LOW position
may be further regulated by means of a small adjusting
screw in the center of the valve stem. This screw is
accessible by removing the valve knob, which pulls
straight off the end of the valve stem.
REMEMBER: FOR SAFE MANUAL LIGHTING, PLACE A
BURNING MATCH OR BUTANE LIGHTER BESIDE THE
BURNER - THEN TURN ON THE GAS (see Fig. 11-3).
Fig. 11-2 - Match holder
Read entire instructions before lighting, and follow these instructions each time you light the power burner.
LIGHTING (IGNITION) INSTRUCTIONS
Fig. 11-3 - Manual lighting
Fig. 11-1 - Valve control knob
OFF
HI
LIGHT
LOW
TO
TURN OFF
TO TURN ON
Read setting
here
HIGH to
LIGHT
Read setting
here
TO TURN OFF
TO TURN ON
High to
light
SHUTTING OFF THE POWER BURNER
To shut off the power burner, depress each valve control
knob, and while pressing turn it clockwise to the OFF
position.
Always close the valve to the gas supply after each use
of the power burner.
Outer
burner
control