Digital Thermometer Instructions

REV 2 - A - 2001021430
L-C2-348
1
INSTALLER: Leave these instructions with consumer.
CONSUMER: Retain for future reference.
Fig. 1-1 Removing / connecting
digital thermometer
Thermometer cutout
Digital
thermometer
Wire
connections
Grill
control panel
Echelon Diamond Digital
Thermometer Replacement
Model # 24182-12
This digital thermometer is for replacement on an Echelon
Diamond grill. To install, follow the steps below:
1. Ensure the appliance is completely cool, the knobs are
in the off position, the gas supply to your appliance
is turned off, the master switch is off, and the power
supply is disconnected.
2. Locate the old thermometer on the grill control panel
between the knobs. Remove it from the grill by slightly
sliding it to the left, then lifting the right side outward until
it clears the control panel.
CAUTION: Remove carefully as the wire harnesses will still
be attached to the back of the thermometer.
3. CAREFULLY pull apart the 3 wire harnesses at the
connectors, as shown in Fig. 1-1. When disconnecting,
be sure to pull from the connectors and not the wires.
CAUTION: Pulling connections apart from the wires may
cause damage to your unit.
4. Apply a small amount of dielectric grease to the new
thermometer wire harnesses and connect to the exposed
wire harnesses coming out of the grill (see Fig. 1-1).
CAUTION: The wire harnesses must be properly connected
as shown in Fig. 1-2 (the clips and tabs must
align, allowing for easy connections). All 3 wire
harnesses have differently sized or shaped
connectors to ensure a proper install.
DO NOT FORCE the connections together.
5. Carefully install the thermometer into the cutout on the
control panel.
This completes installation, refer to the owner’s manual
included with your grill for digital thermometer operation.
Fig. 1-2 Proper connections
Clip
Ta b