Use and Care Manual

STARTING THE ENGINE
5. OPERATING PROCEDURES
(a) Make certain the generator is on a flat, level surface.
(b) Disconnect all electrical loads from the generator.Never start or stop the
generator with electrical devices plugged in or turned on.
(c)Turn the fuel cap vent lever to the “ON” position.
Page 13
(d) Turn the fuel valve to the “On” position.
(e) Pull choke lever out to the “Choke” position.
(h) As engine warms up, push the choke lever to the “Run” position.
ON
OFF
(f) Turn the engine switch to the “On” position.
(g)Pull the starter cord slowly until resistance is felt and then pull rapidly.