Use and Care Manual

USING ELECTRIC POWER
Be sure to ground the generator if the connected electrical equipment is grounded.
NOTE:
(a) Check the digital display for proper voltage.
(b) Turn off the switch(es) of the electrical
appliance(s) before connecting to the
generator.
(c)Insert the plug(s) of the electrical
appliance(s) into the receptacle.
(d) Check the amperage of the socket, and
be sure not to take a current exceed the
exceed the specified amperage.
This generator is thoroughly tested and adjusted in the factory.
If the generator does not produce the specified voltage, consult your nearest
FIRMAN Generator dealer.
Be sure that the total wattage of all
appliances does not exceed the rated
output of the generator.
When the circuit breaker or no-fuse breaker turns off during operation, the generator is
overloaded or the appliance is defective.
Stop the generator immediately, check the appliance and /or generator for overloading
or defect and repair as necessary.
(e) Make sure the AC CIRCUIT BREAKER is
"ON". If the breaker is "OFF", set the
breaker “ON”.
Page 17
WARNING