User Manual

NEVER USE WATER TO CLEAN GENERATOR.
Pull starter handle until resistance is felt, leaving
handle in that position.
Store generator in a well ventilated, low humidity
area.
Page 23
SERVICE AND STORAGE
WARNING
Generator exhaust contains odourless and
colourless carbon monoxide gas.
To avoid accidental or unintended ignition of
your generator during periods of storage, the
following precautions should be followed:
When storing the generator for short or
extended periods of time make sure that the
Engine Switch and the Fuel Valve are set in the
OFF position.
Infrequent Service
If the unit is used infrequently, difficult starting
may result. To eliminate hard starting, follow
these instructions:
1. Run the generator at least 30 minutes every
month.
2. Run the generator, then close the fuel shut-off
valve and allow the unit to run until the engine
stops.
3. Move the engine switch to the "OFF" position.
Long Term Storage
When the generator set is not being operated
or is being stored more than one month, follow
these instructions:
1. Replenish engine oil to upper level.
2. Run the generator, then close the fuel shut-off
valve and allow the unit to run until the engine
stops.
3. Move the engine switch to the "OFF" position.
•
•
NOTE: We recommend always using a fuel
stabilizer. A fuel stabilizer will minimize the
formulation of fuel gum deposits during
storage. The fuel stabilizer can be added to
the gasoline in the fuel tank, or into the
gasoline in a storage container.
English Customer Service: 1-844-FIRMAN1
4. After the unit has cooled, drain gasoline from
fuel tank, fuel line and carburetor.
•
Turn the fuel valve to the “OFF”(O) position.
•
Remove fuel cap and fuel tank filter.
Use a siphon to transfer gasoline from generator
into a gasoline approved container. Wipe up any
spilled fuel with a clean rag.
•
•
Start generator engine and let it run until it
stops and all remaining fuel is consumed. Do
not connect electronic devices to generator
during this process.
•
Remove maintains cover screws, then remove
maintains cover.
•
Drain fuel from carburetor by loosening the
drain screw on the carburetor float chamber.
Turn the fuel valve to the “OFF”(O) position.
•
Tighten the drain screw. Install the maintains
cover and tighten screws.
•
5. Pour about one teaspoon of engine oil through
the spark plug hole, pull the recoil starter
several times and replace the plug. Then pull
the starter until you feel the piston is on its
compression stroke and leave it in that
position. This closes both the intake and
exhaust valves to prevent the inside of the
cylinder from rusting.
6. Cover the unit and store in a clean, dry place
that is well ventilated away from open flame
or sparks.