Use and Care Guide

13
Installation instructions
Important!

All connections must be checked for leaks.

Ensure white ¼” (6 mm) tubing is routed away from sharp objects, sharp corners (beware of
kinking the tube as this will stop water flow), clear of the refrigerator rear compartment and not
in a location where it can be kinked or squashed.

Ensure all push-fit connections are firmly pushed into place. The tube should push in ⁄” (16 mm)
before reaching the stop.

If tubing is removed at any point, re-cut the end and re-insert. Tubing must be fully inserted to
avoid leaks.

To remove tube from connection points first turn off the isolating faucet. Gently push the
dispensing pad a few times using a glass or container to remove the static line pressure. Push in
the collet firmly while pulling back on the tubing at the same time, as shown in Diagram 10.
6 7 8 9
DRAWING: 838587
PART: 838587
Diagram 11
Diagram 10
Fig.9 Connection to water supply
System tested and certified by NSF International against NSF/ANSI Standard 53 for the reduction
of Asbestos, Atrazine, Benzene, Cyst, Carbofuran, Lead, Lindane, Mercury, P-Dichlorobenzene,
Toxaphene & Turbidity; against Standard NSF/ANSI 42 for the reduction of Chlorine Taste and
Odor and Nominal Particulate Class I to a capacity of 750 gallons (2,838 liters).
US
CA