User Manual

64
CARE AND CLEANING
Replacing the semi-rapid burner caps
Burner parts
y You can remove and clean these parts with hot soapy water or non-abrasive detergents.
Clean spills regularly before they become burnt on. Do not wash these parts in a
dishwasher.
y After cleaning, check that the burners and their flame spreaders are dry before replacing
correctly.
y It is very important to check that the burner flame spreader and the cap have been
correctly positioned. Failure to do so can cause serious problems.
y Check that the ignitor is always clean to ensure trouble free sparking. It must be cleaned
very carefully using a toothbrush and methylated spirits.
y Note: to avoid damage to the electronic ignition, do not try to light a burner without all
burner parts in place.
Replacing the burner parts
y Carefully replace the burner parts as per the following illustrations.
y Fit the flame spreader to the housing as shown below. Make sure the burner is not able
to rotate.
Check that:
y The ignitor is always clean to ensure trouble-free sparking.
y The probe is always clean to ensure correct operation of the safety valves
y The flame spreaders are clean and the holes are not clogged.
y Note: both the ignitor and probe must be very carefully cleaned using a toothbrush and
methylated spirits.
Replacing the semi-rapid burners
S
F
C
T
Cap
Flame
failure
probe
Ignitor
Flame
spreader
Correct positioning of burner parts