Installation Guide
37
@5CABINET TRIMS INSTALLATION—[A] FLEXIBLE SPRING CLIP METHOD
4
Place three side trim brackets onto each
sidetrim.
Note: Measure from the top of the trim,
with the shorter lip at the bottom.
Refer to (B) for 80 and 84 bracket
locations and trim orientation).
IMPORTANT!
Each bracket has two engagement points
for the side trim to locate. Ensurethe trim
is engaged in both points (C).
Repeat for the remaining side trim.
80" = 9 (229mm)
84" = 13 (330mm)
80" = 36 (914mm)
84" = 40 (1016mm)
80" = 65 (1651mm)
84" = 69 (1753mm)
0
B
1
Break off the datum lip to each side trim
bracket and discard.
Repeat for all side trim brackets.
Discard
Top view of side trim engaged
correctly in side trim bracket
C
Side trim
bracket
Side trim
TWO METHODS ARE AVAILABLE FOR ATTACHING CABINET SIDE TRIMS:
[A] FLEXIBLE SPRING CLIP METHOD — RECOMMENDED METHOD
[B] FIXED SCREW METHOD — METHOD TO USE IF CABINET IS NOT TO SPECIFICATION
(Attempt method [A]. If method [A] results in poor fitment of side trims due to cabinetry that is uneven or out of specification, use method [B]).
A
Plastic
Aluminum
For 80 (2032mm) cavity installation only
2
Measure 4 (102mm) from the top of
theside trim with a square ruler and mark
acutting line (A).
3
Cut along the line using a fine tooth
hacksaw to a length of 76 (1930mm) (B).
IMPORTANT!
Ensure the cut is straight and square
asthisis an exposed surface.
Ensure the plastic part does not bend
asthis can causevisual stressmarks.
Repeat for all sidetrims.
short lip
Internal box
D
Cabinet side
trim install kit
Side trim bracket
(6)
Spring clip
(6)
External box
Cabinet side trim
(2)
Tools
Hacksaw
Pencil