Installation Guide
Table Of Contents
- Safety and warnings
- Integrated refrigerator & freezer
- Integrated refrigerator-freezer
- Integrated wine cabinet
- Supplied parts
- Required parts
- Door panel kit
- Handle kit
- Hinge change kit
- Wine display accessories
- Tools
- Product dimensions
- Cabinetry dimensions — Single installation
- Cabinetry dimensions — Multiple installation
- Stainless steel Door panel dimensions — Single installation
- Custom Door panel dimensions — Single installation
- Custom Door panel dimensions — Multiple installation
- Toe kick dimensions
- Installation options
- Door clearance
- Drawer clearance
- Electrical and plumbing
- Custom door panel install dimensions
- Before installation
- Cavity preparation
- Appliance preparation
- Door panel preparation — Stainless steel panel
- Door panel preparation — Custom panel
- Door panel preparation — Wine cabinet only
- Power and water supply connection
- Install water filter
- Single installation — Align appliance into cabinetry
- Single installation — Secure appliance into cabinetry
- door panel installation
- Toe kick installation
- Grilles installation
- Carbon filter installation
- Air flow divider installation
- Cabinet trims installation
- Top trim & hinge pocket covers installation
- Multiple installation — Appliance preparation
- Multiple installation — Align first appliance into cabinetry
- Multiple installation — Secure first appliance into cabinetry
- Multiple installation — Align second appliance into cabinetry
- Multiple installation — Secure second appliance into cabinetry
- Multiple installation — Install cabinet trims
- Wine display for Wine cabinet (optional)
- Change the door hinges (optional)
- Final checklist
29
BEFORE INSTALLATION
Removing pre-installed parts Moving your appliance
Be careful when tilting the appliance forward/backward. Tape the door shut to prevent
opening while moving the appliance. You need at least two persons to move this appliance.
1
2
3
4
Remove the brackets from the
non-hinge side of the pallet.
Tilt the appliance slightly forward
and insert the hand truck between
pallet and appliance.
Restrain the appliance with
strap and remove the remaining
brackets.
Tilt backward to load the appliance
onto the hand truckandsetaside
thepallet
Pushthehandtrucktothe
installationlocation
Hand truck
Strap
Top trim
Disengage one end of the top trim from dual lock
strips on the non-hinge side of the appliance.
Slide the top trim out from the hinge pocket of the
appliance.
Top door cover
Remove the trim caps of the top cover carefully from
both ends of the top of the door.
Ensure the magnet remains in place and not
damaged as this will affect the operation of the
appliance.
Toe kick mounting plate
Remove the screws to detach the toe kick mounting
plate.
Air flow divider
Remove the screw to detach the air flow divider.
Set aside all the removed parts to reuse later.
Top grille*
Open the door and remove hinge pocket cover using
a flat head screwdriver in theslot.
Open the water filter hatch on the bottom grille and
unscrew the #8x16 screw.
Remove the bottom grille by unscrewing the #8x16
screws from both ends of the grille.
*Top grille for Refrigerator-Freezer different from illustration.
Bottom grille
The bottom grille is detachable via magnets.
Illustrations may differ from your purchased appliance.