Frameless Cabinetry Installation Guide

24
!3 ASSEMBLE DOOR PANEL SET
The assembly of Fisher & Paykel (EZKleen stainless steel) and DCS (Stainless steel) door panels and custom door panels are outlined below. To protect the finish of the Fisher & Paykel EZKleen
stainless steel and DCS stainless steel door panels, leave protective film on the panels when hanging and remove film only when installation is complete.
If using custom door panels ensure they are prepared as per ‘Custom door panel dimensions’ section.
2
Hanging bracket (refer to B)
For Fisher & Paykel door panel sets or DCS door
panel sets, align the bracket to the holes and
secure with screws x6 (M5 x 14 Mush Phillips SS).
For custom panels, secure bracket with screws
x6 (#8 x 16 Mush washer screws).
Door panel
1
Mounting handle (refer to A)
For Fisher & Paykel door panel sets or DCS door
panel sets, remove the plastic plugs from the
handle holes x4. Align the handle to the holes
and secure with screw handle x4 (M5 x 25 pan
head socket screws).
For custom panels, ensure handle is secured
29/16” (65mm) from the inner edge of the
panel to the center – this will avoid interference
with bracket installation.
Drawer door panel
4
Mounting handle (refer to D)
For Fisher & Paykel door panel sets or DCS
door panel sets, remove the plastic plugs from
the handle holes x4. Align the handle to the
holes and secure with screw handle x4 (M5 x
25 pan head socket screws).
For custom panels, ensure handle screw heads
are counter sunk into the back of the panel to
avoid interference with hanging bracket.
5
Hanging bracket (refer to E)
For Fisher & Paykel door panel sets or DCS
door panel sets, align the bracket to the holes
and secure with screws x6 (M5 x 14 Mush
Phillips SS).
For custom panels, secure bracket with screws
x6 (#8 x 16 Mush washer screws).
6
Side brackets and straps (refer to F)
For Fisher & Paykel door panel sets or DCS
door panel sets, align bracket and strap to the
holes on the side of the panel and secure with
screws x2 (M5 x 14 Mush Phillips SS).
For custom panels, secure bracket with screws
x2 (#8 x 16 Mush washer screws).
Repeat this process for all brackets and
straps.
D
E
3
Side brackets and straps (refer to C)
For Fisher & Paykel door panel sets or DCS
door panel sets, align bracket and strap to the
holes on the side of the panel and secure with
screws x2 (M5 x 14 Mush Phillips SS).
For custom panels, secure bracket with
screws x2 (#8 x 16 Mush
washer screws).
Repeat this
process for all
brackets and
straps.
F
A
B
C