Frameless Cabinetry Installation Guide

3
1 SAFETY AND WARNINGS
!
WARNING!
Electric Shock Hazard
Read and follow the safety and warnings outlined in this installation
instructions guide before operating this appliance.
Failure to do so can result in death, electric shock, fire or injury
topersons.
!
WARNING!
Cut Hazard
Take care – panel edges are sharp. Failure to use caution could result in
injury or cuts.
!
WARNING!
This appliance is top-heavy and must be secured to prevent the
possibility of tippingforward.
To ensure that the appliance is stable under all loading conditions,
theanti-tip bracket and fittings supplied must be installed according
tothe following installation instructions by a professional installer.
IMPORTANT!
SAVE THESE INSTRUCTIONS
The models shown in this installation guide may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please go to
our website www.fisherpaykel.com or www.dcsappliances.com or contact your local Fisher & Paykel dealer.
2 BEFORE INSTALLATION
Please follow the installation steps specified to ensure your appliance is installed and
operatescorrectly.
Refrigeration alcove preparation

For integrated installation, a finished return of solid material is required across the top and
sides of the new or existing alcove.

It is recommended that the return be at least 3 1/2” (88.9mm) deep across the sides.
Refer to page13 prior to installation of the appliance.
2 BEFORE INSTALLATION
Power

To ensure that the appliance is not accidentally switched off, connect your refrigerator to its
own isolating switch. Do not plug in any other appliance at this isolating switch.

For power requirements, please refer to the information on the serial plate. This is located
atthe front right-hand side of the drawer when open.

It is essential that the appliance is properly grounded (earthed).

Connect the appliance to the electrical supply (115VAC, 60Hz) with the fitted plug and lead.

Follow the National Electrical Code and all local codes and ordinances when installing
thisproduct.

Warning: Ground Fault Circuit Interrupters (GFCI) may trip during normal operation of your
refrigerator and interrupt the power supply. The use of a GFCI is not recommended with
thisproduct.
Location

Your refrigerator should not be located in direct sunlight or next to any heat generating
appliance such as a cooktop, oven or dishwasher.

Your product is fitted with front and rear rollers designed for moving the product in
forwards and backwards direction.

Avoid moving the product in a sideways direction as this may damage the rollers or the floor
covering/surface.
Plumbing

Your product must be installed by a qualified appliance installer as incorrect plumbing can
lead to water leaks.

Fisher & Paykel Appliances and DCS by Fisher & Paykel Appliances do not accept
responsibility for damage (including water damage) caused by faulty installation or plumbing.
Door panel set

The standard appliance does not include a door panel set.

Custom door panels can only be used with non-Water dispensing models.

For a custom integrated design on non-Water dispensing models, customers would supply
their own custom door panel set to match their cabinetry. All the hardware required to
mount the door panel sets to the refrigerator doors is supplied with the appliance.

Door panel sets are available through your Fisher & Paykel dealer.
– Fisher & Paykel door panel sets are available (EZKleen stainless steel door panels) model
numbers: RD3680(L/R), RD3680RU, RD3684(L/R) and RD3684RU.
– DCS door panel sets are available (stainless steel door panels) model numbers:
RD3680(L/R)C, RD3680RUC, RD3684(L/R)C and RD3684RUC.

Handle sets are optional for custom door panels and can also be purchased through your
Fisher & Paykel dealer.