Installation Guide

16
IMPORTANT!

Ensure your appliance is not exposed to any heat generating appliance eg cooktop,
ovenordishwasher.

The appliance has front and rear rollers for moving the appliance forward and
backward. Donotmove the appliance sideways to avoid damaging the rollers or the floor
covering/surface.

The appliance must be installed by a qualified installer, or Fisher & Paykel trained and
supported service technician to avoid faulty electrical connection and water leaks.

All connections for water, electrical power and grounding must comply with local
codesand ordinances and be made by licensed personnel when required.

Avoid installation of the appliance/s under a ground fault circuit interrupter (GFCI).

Ensure the appliance is installed properly. Improper installation that results in appliance
failure is not covered under the appliance warranty.
Check installation location
1 Check the cabinetry
– Check the dimensions—height, width, depth, floor level, finished
alcovereturns.
– Ensure that the ventilation openings in the cabinetry are clear of obstruction.
– For integrated installation, a finished return of solid material is required
across the top and sides of the new or existing alcove.
– It is recommended that the return should be at least 3 1/2" (89mm)
deepacross the sides.
– Refer to ‘Cavity Dimensions’ prior to installation of the appliance.
2 Check the power supply
– Ensure that there is a separate power outlet for the appliance.
– Avoid sharing the power point with other appliances to prevent the
appliance from accidentally switching off.
– For power requirements, refer to the information on the serial plate.
Thisislocated at the front right-hand side of the drawer when open.
– Ensure your appliance is properly grounded (earthed).
– Connect the appliance to the electrical supply (115VAC, 60Hz) with fitted
plug and lead.
– We recommend to use an isolating switch that is easily accessible
to the user after the appliance is installed.
– Follow the National Electrical Code and all local codes and ordinances
when installing this appliance.
3 Check the water supply (for Ice and Water models only)
– Ensure that there is a separate water supply connection for the appliance.
– Your appliance must be installed by a qualified appliance installer as
incorrectplumbing can lead to water leaks.
– Fisher & Paykel is not liable for damage (including water damage)
causedby faulty installation or plumbing.
!2BEFORE INSTALLATION