Installation Guide

22
IMPORTANT!

DO NOT install the appliance on a soft, uneven, or unlevelled floor
to avoid twisting the appliance and poor door sealing.

Raise the appliance using a 7/16" (11mm) hex socket or 3/16" (4mm) hex key.

One turn of height adjusting nuts is equivalent to 1/16 (1mm) height adjustment.
Note: Maximum turn is 13/16" (20mm).

Ensure that the top, bottom and side gap differences are not greater than
1/16"(1.5mm) to achieve correct alignment.

If using a powered driver, use low torque setting to avoid the nut
disengaging from the rod and damaging theleveling system. If the nut
disengages, use the hex key to realign with rod.

Finalalignment will be achieved once door panels have been installed
andthe appliance is pushed back to sit flush with the cabinetry.
Tools
Hex key
Ruler
Cross-head screwdriver
Powered driver (optional)
!8ALIGNING INSIDE CABINETRY
Align appliance inside the cabinetry
1
Centre the appliance within the alcove, using the adjacent
walls as a guide.
2
Turn the front and rear adjustment nuts (A) using a hex key to
extend the feet until it engages the floor.
– Clockwise turn raises the height and counter-clockwise
turn lowers the height.
3
Continue turning the adjusting screws alternately between
front and rear feet to align the front of the doors top to
bottom on both sides, and until you achieve the correct
alignment.
4
Check the top and bottom, left and right gaps by placing
aruler (B) on the front of the appliance.
– Ensure the gaps between appliance and adjacent
cabinetry are even on both sides (C).
– This step will help ensure the appliance is level with the
adjacent cabinetry.
5
Gently push the front of the appliance to check the stability.
C
A A
Front roller adjustment
Rear roller adjustment
Place a ruler on the
front of the appliance to
check flushness top and
bottom, left and right.
B