Installation Guide

23
Remove hanging brackets
1
Remove the M8 washers and M8 nuts fromthe
M8studs at the top the door (A). Keep the washers
and nuts to reuse later.
2
Remove the hanging bracket from the top of each
door and set aside (B) for later installation.
IMPORTANT!

Follow these steps to avoid difficulties in door panel adjustment and cosmetic cap fitment.

Ensure to protect the finish of the Stainless steel door panels.

For non-water dispensing door panels: Leave the protective film on the panels when hanging and remove the film only when installation is complete.
E
Attach the door and drawer handles (C)
3
Remove the plastic plugs from the handle
holes (4 per each door panel).
4
Align the handle holes with the door panel
holes and secure with M5x25 pan head
socket screws (4 per each door panel).
D
Attach the hanging brackets (D)
5
Align the bracket to the holes and secure
with M5x14 mush cross-head SS screws (12).
C
C
Attach side brackets and straps (E)
6
Align the brackets and straps to the holes on
the side of the panel and secure with M5x14
mush cross-head SS screws (12).
D
Internal box
B
Door panel
attachment kit
Side bracket
(10)
Side strap
(10)
Door handle kit
M5 x 25 Pan Head Socket Screw
M5 x 25 Pan Head Socket Screw
M5x25 pan head socket
screw (8)
Door panel set
M5 x 14 Mush Head SS Philips Screw
M5 x 14 Mush Head SS Philips Screw
M5x14 mush cross-head
(SS) screw (24)
Tools
Hex key FPA spanner
Cross-head screwdriver
Torx screwdriver
!9DOOR PANEL INSTALLATION—STAINLESS STEEL
B
A