Installation Guide

26
IMPORTANT!

Follow these steps to avoid difficulties in door panel adjustment and cosmetic cap fitment.
4
Secure side bracket forks by
tightening side screws(C).
Note:
– For depth adjustment, loosen the side screws (4),
adjustthe panels and then retighten oncesatisfied.
– Further adjustment of door panels can be achieved
byremoving door panels then loosening the fixing
screws for the hanging bracket and moving the
bracket sideways to suit.
5
Loosely install locking bracket into the pocket on the
underside of the door using a M8 stud (D).
– Slide the locking bracket out until it touches the back
of the door panel. Fully tighten the M8 stud.
– Screw in place using a #8x16 screw through one
ofthe three slotted holes.
C
B
A
D
Adjust the door panels
1
Place a ruler on the front of the appliance to check
flushness top and bottom, left and right.
– Ensure the gap between the top of the door panel
and the top cabinetry is not more than 1/4" (7mm).
– To reduce this gap, raise the appliance by turning all
four adjustment nuts the same number of turns.
2
Each door panel has full axis adjustment to ensure
flushness with adjacent walls. To adjust the height
ofthe panel, turn the stud clockwise to raise or
counter-clockwise to lower the door panel (A).
3
Once satisfied with the alignment, secure M8 studs
with M8 washer and M8 nut (B). The top of the stud
must remain below the top face of the door panel.
Tools
FPA spanner
Hex key
Cross-head screwdriver
Powered driver (optional)
Ruler
#8 x 16 Mush Washer Twin Thread Philips Screw
#8 x 16
Mush Washer
Twin Thread
Philips Screw
#8x16 mush washer screw
(1)
!9DOOR PANEL INSTALLATION—STAINLESS STEEL