Installation Guide

4 SCREW THE TRIM SURROUND ONTO THE CABINETRY
Secure the Trim Surround using the
screw hole locations shown
Using the 4 supplied screws, secure the Trim
Surround to the cabinetry in the correct hole
positions, as shown.
Pre-drill as necessary to avoid splitting the
wood.
IMPORTANT!
Do not screw through either center holes in
the Trim Surround.
5 SECURE THE TWO SUPPORT BRACKETS IN THE CAVITY
1 Position left and right support
brackets as shown inside, against
the walls of the cavity.
We recommend butting the
brackets up against the rear
frame of the Trim Surround.
2 Secure through front and rear
hole locations on both brackets
using the screws supplied.
Support
Bracket
6 FIT THE FOUR RUBBER HOLE PLUGS
Fit the 4 supplied rubber plugs into the Trim
Surround in the correct hole positions, as
shown.
x4
7 INSTALL YOUR COFFEE MAKER (REFER TO SEPARATE INSTRUCTIONS SUPPLIED WITH COFFEE MAKER)
1 Install your Coffee Maker as per it’s installation
instructions. Ensure the slides are secured correctly
2 Position your Coffee Maker in the cavity. Ensure the
Coffee Maker and Trim Kit are correctly aligned and
the Coffee Maker can open and close freely, before
securing.
591791A 10.18