Installation Guide
Table Of Contents
13
INSTALLATION INSTRUCTIONS
7
Attach U-shaped hose guide to the end of the drain
hose. Place the hose in a standpipe.
Note: if the drain hose is placed in a standpipe
without forming a U shape, a siphoning action could
occur. There must be an air gap around the drain hose.
A snug hose fit can also cause a siphoning action.
Note: do not place drain hose deeper than 7” (177.8mm) into the drain. The suggested
depth is 4–7” (101.6–177.8mm). Deeper than 7” (177.8mm) can cause a siphoning action.
8
Plug the power cord into a grounded outlet.
Note: check to be sure the power is off at the circuit breaker/fuse box before plugging
the power cord into an outlet.
9
Turn on the power at the circuit breaker/fuse box.
!0
Read the rest of this User guide. It contains valuable and helpful information that will
save you time and money.
!1
Before starting the washer, check to make sure:
●
Main power is turned on.
●
The washer is plugged in.
●
The water faucets are turned on.
●
The unit is level and all four leveling legs are firmly on the floor.
●
The shipping support hardware is removed and saved.
●
The drain hose is properly tied up.
●
There are no leaks at the faucet, drain line or washer.
!2
Run the washer through a complete cycle. Check for water leaks and proper operation.
!3
If your washer does not operate, please review the ‘Troubleshooting’ section before
calling for service.
!4
Place these instructions in a location near the washer for future reference.
IMPORTANT!
●
The hot water temperature should not exceed 149°F (65°C) and the cold water
temperature not exceed95°F (35°C). Temperatures above these may cause the
machine to fault or cause damage to the machine.
●
New hose sets provided with the washer should be used to connect the washer to the
water mains.
●
Old hose sets should not be re-used.
●
We recommend the inlet hose(s) are changed every 5 years. WARNING: Failure to do
so may result in a flood and damage to property.
Installing the drain hose