L9182 www.fisher-price.
Assembly UPPER RAMP TAB LOWER RAMP #4 x 1/2" Screw • Fit the tabs on an upper ramp into the slots in a lower ramp. • Insert two screws into the upper ramp. Tighten the screws with a Phillips screwdriver. Do not over-tighten. • Repeat this procedure to build the other upper/lower ramp assembly. SUPPORT TOP “Snap” a support top onto two support columns.
Assembly Elevation Track Tips UPPER RAMP 1 You can stack up support column assemblies to make a higher track layout. TAB 3 LOWER RAMP #4 x 1/2" Screw CURVED TRACK NOT INCLUDED • Fit the tabs on an upper ramp into the slots in a lower ramp. • Insert two screws into the upper ramp. Tighten the screws with a Phillips screwdriver. Do not over-tighten. 2 • Repeat this procedure to build the other upper/lower ramp assembly.
Parts A. 6 Straight Tracks B. 4 Short Tracks C. 6 Support Tops D. 2 Upper Ramps E. 2 Lower Ramps F. 12 Support Columns G. 2 Guardrails H. #4 x 1/2” Screw – 4 Please keep this instruction sheet for future reference, as it contains important information. A B x6 x4 D C Adult assembly is required. Tool required for battery installation: Phillips screwdriver (not included). x6 x2 WARNING This product contains small parts in its unassembled state. Adult assembly is required.
For layout ideas visit the GeoTrax® section of www.fisher-price.com Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. ©2007 Mattel, Inc. All Right Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
