Building Set User Manual

“Snap” a support top onto
two support columns.
Assembly
• Fit the tabs on an upper ramp into the slots in a lower ramp.
• Insert two screws into the upper ramp. Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
• Repeat this procedure to build the other upper/lower ramp assembly.
UPPER RAMP
SUPPORT TOP
SUPPORT COLUMN
Elevation Track Tips
You can stack up
support column
assemblies to
make a higher
track layout.
1
To properly support elevated
tracks, always make sure you
have support columns under
track connections.
2
TAB
LOWER RAMP
CURVED TRACK
NOT INCLUDED
3
• When using a curved track (not included) at the bottom of a ramp assembly, be
sure to use a guardrail on the curve. This keeps the fast moving train on the track!
• To attach the guardrail, fit a tab on one end of the guardrail under the curved
track, as shown.
• Bend the guardrail slightly to fit the other two tabs to the curved track.
#4 x
1
/
2
" Screw