Manual

2
No-Motion Pinpoint Mode With VCO Audio: At the push of a
button, the all-metal no-motion pinpoint mode kicks in with
VCO (Voltage Controlled Oscillator) audio response for
precise target locating. A located target responds with
increasing volume and pitch. The tone gets louder and higher,
so there’s virtually no doubt when you’re directly over a
target.
VOLUME Control: For an extra measure of versatility, we’ve
included a VOLUME control so you can set the audio level to
suit your needs. You’ll no longer have to buy a special headset
with extra controls to adjust the audio level.
FREQUENCY Control: You can vary the transmit frequency of
your 1236-X2 from 5.5 KHz to 5.9 KHz. This control allows you to
eliminate electrical interference from nearby metal detectors.
A must for competition hunting.
User Setpoints And Factory Presets: The SENSITIVITY, VOLUME,
FREQUENCY, and DISC controls all have recommended user
setpoints that are indicated by a red-colored number on each
control’s number dial. These setpoints provide a useful starting
point for the new user. In addition, we’ve included a
convenient factory preset IRON discrimination setting. When
the DISC control is fully rotated counterclockwise to the IRON
position, the 1236-X2 is set to reject common iron trash and
nails.
Battery Test: A convenient battery test switch has been
incorporated into your 1236-X2 to check the relative strength
of the batteries. Rotating the SENSITIVITY control
counterclockwise to the “BATTERY” position causes the 1236-X2
to give off an audio tone with the intensity indicating the
strength of the battery. A low or absent audio tone indicates a
weak or dead battery.
ABOUT YOUR DETECTOR