User's Manual

Isotempâ Laboratory and Chromatography Refrigerators
Page 3 of 12
Part Number: 104416
Tab Length
Shelf Support
Shelves
4. The spring tension can be adjusted by moving the spring to
the outside hole of the bracket or by snipping a portion of it off
and then refastening it to the bracket.
CAUTION: Where safety glasses before snipping spring.
Shipped inside each cabinet are shelves packed in plastic and a bag
of shelf supports. Two different types of shelf supports are used.
The shelf supports have tab lengths of ¼ inch and ½ inch. The ¼
inch versions are used in the front of the shelf (See below) and the ½”
shelf supports are used in the rear.
Shelf spacing is adjustable to suit user requirements. Insert four shelf
supports for each shelf into the pilasters as shown. Note the
numbers on the pilasters. Place supports on the same numbers on
each pilaster to ensure the shelf will be level. Place the shelf on the
pilasters as shown in Fig’s 2 and 3.
Replacement shelves are available individually. See page 11 for
shelf part numbers. Proper shelf orientation is illustrated in Figure 2.
NOTE: Chromatography units include additional ½ shelves, which
can be used in place of the full shelves.
Fig. 2 Use ¼” tab length supports on sides and ½’ in back.