L0540 Newborn Baby Toddler Older Baby WARNING IMPORTANT! KEEP INSTRUCTIONS FOR FUTURE REFERENCE. www.fisher-price.
Consumer Information Parts IMPORTANT! Please remove all parts from the package and identify them before assembly. WARNING To prevent serious injury or death: • Fall Hazard - It is dangerous to use this product on an elevated surface, since child’s movement may cause the product to slide or tip over. Use only on a floor. • Suffocation Hazard - Never use on a soft surface (bed, sofa, cushion) since the product can tip over and cause suffocation in soft surfaces. • Never leave child unattended.
Assembly IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Mattel for replacement parts and instructions if needed. Never substitute parts. Crossbar 3 • Insert and "snap" the back rails into the sockets in the side rails. Pull up on the back rails to be sure they are secure. Side Rails 1 • Place the side rails on a flat surface.
Assembly Pad Seat Back Tube Socket Socket 5 • Insert the ends of the seat back tube (inside the pad) into the sockets in the front rail. Push down on the seat back tube until you hear a “click” on each side. • Pull up on the seat back tube to be sure it is secure. 6 • Locate the pocket in the bottom of the pad. • Fit the hardboard (attached to the front bar) into the pocket in the pad.
Assembly Toy Bar Clamp 9 • Fit the toy into the slot in the top of the front rail. • Fit the toy bar clamp to the top of the front rail. Push the toy bar clamp down to “snap” it into place. Hint: To remove the toy bar, lift the edge of the clamp and pull to remove.
Battery Installation Hint: We recommend using an alkaline battery for longer battery life. + "D" (LR20) 1,5V x 1 - Battery Safety Information In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product.To avoid battery leakage: • Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium). • Insert batteries as indicated inside the battery compartment.
Newborn-to-Toddler Portable Rocker Newborn Baby Toddler Older Baby 7
Setup WARNING To prevent serious injury or death: • Use the upright position only when child has developed enough upper body control to sit without leaning forward. • Reclined position not recommended for children who cannot sit up by themselves (6 months approximately, until 9 Kg/20 lbs).
Soothing Vibrations and Fun Music Fold for Portability and Storage PRESS 1 • Make sure your child is properly secured in the seat. • Slide the power switch on the soothing unit to for vibrations and O to turn vibrations off. Note: If vibrations from the soothing unit become faint, or if there are no vibrations, remove the battery from the soothing unit and dispose of it properly. Replace the battery with a new “D” (LR20) alkaline battery.
• The pad is machine washable. Wash it separately in cold water on the gentle cycle. Do not use bleach.Tumble dry separately on low heat and remove promptly.The frame, toy bar and toys may be wiped clean using a mild cleaning solution and a damp cloth. Do not use bleach. Do not use harsh or abrasive cleaners. Rinse clean with water to remove residue. Do not immerse the frame or the toys. To remove the pad: • Unfasten the pad flaps. • Remove the pad clips from the front bar.