INSTRUCTION MANUAL MANUAL DE INSTRUCCIONES VACUUM CLEANER SC-TA3000 TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS PART NAMES & ASSEMBLY USING THE VACUUM CLEANER USING THE ATTACHMENTS EMPTYING THE DUST CONTAINER MAINTENANCE TROUBLESHOOTING & SPECIFICATIONS WARRANTY SPANISH 2-3 4 5-6 7 8 9 10 11 12-21 Read these instructions carefully before using your vacuum cleaner.
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING - To reduce the risk of fire, electric shock or injury: 1. Do not leave the vacuum cleaner when plugged in. Unplug it from the outlet when not in use and before servicing. 2. Do not use outdoors or on wet surfaces. 3. Do not allow vacuum cleaner to be used as a toy.
CAUTION FIRE CAUTION Do not expose vacuum cleaner to open flames while operating or during storage. Never disconnect the plug by pulling on the cord. To disconnect Grasp plug to from an outlet, grasp the plug, disconnect. not the cord. Flames may be made larger from the vacuum cleaners exhaust, resulting in a fire. Short circuit or fire may occur due to possible warping of the main unit. May result in fire due to electrical shock or short circuit. Unplug from outlet when not in use.
PART NAMES & ASSEMBLY THIS VACUUM CLEANER IS INTENDED FOR HOUSEHOLD USE ONLY. CORD RETAINER While cleaning, use the cord retainer to prevent the power cord from becoming entangled around your feet.
USING THE VACUUM CLEANER 1. Attach the floor nozzle and main unit together. [HOW TO DETACH THE FLOOR NOZZLE] To detach the floor nozzle, insert a screwdriver into the hole and pull up while pushing Lock Button the lock button. Floor Nozzle Detach Hole 2. Remove the dust container and connect the handle and main unit together. HANDLE NUT 1 Insert the handle into the BOLT 2 Insert the bolt and nut hole in the main unit and press tightly, as shown. 3 From the back side, into the bolt hole.
5. Turn on the switch. 1 Press down with your foot on the handle release pedal and pull back on the handle until it releases from its upright position. (At about 30˚, it will relock. Press down on the handle release pedal again to move to the parallel position.) 2 Press down with your foot on the on/off switch pedal to turn the unit on. Press once again to shut it off. 2 Press the on/off switch pedal. 1 Press the handle release pedal.
USING THE ATTACHMENTS CLEANING WITH THE CREVICE TOOL, WAND, AND BRUSH 1. Remove the hose from the main unit. HOSE 2. When inserting the crevice nozzle, wand or brush, insert tightly onto the end of the hose. Firmly insert the desired attachment onto the end of the hose. After use, connect the end of the hose firmly back into the main unit. CAUTION Do not pick up a large amount of dust at once, or objects that are noticeably larger than 3/4 inch in size.
EMPTYING THE DUST CONTAINER CAUTION Carefully empty out dirt and debris. Very fine dirt and dust particles may seal the filter and cause loss of suction, as well as damage to the motor. • Always turn off the vacuum cleaner when emptying the dust container. • Exceeding the “Max” fill line may cause dirt and debris to seal the filter and cause loss of suction.
MAINTENANCE Always turn off the on/off switch pedal and unplug the power cord before servicing. MAIN UNIT • FLOOR NOZZLE • HANDLE • Using a soft, dry cloth, wipe off dirt from the vacuum cleaner. • When the vacuum cleaner becomes extremely dirty, soak a soft cloth in water with a small amount of mild detergent, and wring out well. With the moist cloth, wipe until clean. • Do not use thinner, benzene, or any type of spray cleaner to clean the unit.
TROUBLESHOOTING Before inquiring about service and maintenance, please check the following points listed below. TROUBLE CHECK POINT POSSIBLE SOLUTION Power won’t turn on even when the on/off pedal switch is turned on. Is the power cord plug firmly plugged into the outlet? Insert power cord plug firmly into the outlet. (See page 5) Make sure the hose is attached. (See page 7) Suction power has weakened.
WARRANTY SANYO UPRIGHT VACUUM CLEANER LIMITED WARRANTY OBLIGATIONS SC-TA3000 In order to obtain warranty service, the product must be delivered to and picked up from an Authorized Sanyo Factory Service Center at the user’s expense, unless specifically stated otherwise in this warranty. The names and addresses of Authorized Sanyo Service Centers may be obtained by calling the toll-free number listed below.
INSTRUCCIONES DE SEGURIDAD IMPORTANTES Al usar un aparato eléctrico se deben tener ciertas precauciones, incluyendo las siguientes. LEA LAS INSTRUCCIONES ANTES DE USAR LA ASPIRADORA ADVERTENCIA - Para reducir el riesgo de fuego, golpes eléctricos o heridas: 11. No aspire nada que se esté quemando o humeando, como cigarrillos, fósforos u cenizas. 12. No la use sin el compartimiento de polvo y/o filtros en su lugar. 13. Desconecte todos los controles antes de desenchufar. 14.
PRECAUCIÓN No exponga la aspiradora a fuego aberto mientras lo opera o PRECAUCION durante el almacenaje. de INCENDIO Agarre el enchufe para desconectar se hacen llamas más grande de la abertura de la descarga de la aspiradora, resultando en un incendio. Incendio o cortocircuito puede ocurrir debido al alabeo de la unidad principal que se sobrecalienta. Puede resultar en incendio debido a choque eléctrico o cortocircuito. Desenchufe del tomacorriente cuando no la utilice.
NOMBRE DE LAS PARTES & INSTRUCCIONES DE OPERACIÓN ESTA ASPIRADORA HA SIDO DISEÑADA SOLAMENTE PARA USO DOMÉSTICO.
COMO USAR LA ASPIRADORA 1. Conecte la boquilla de piso con la unidad principal. [COMO QUITAR LA BOQUILLA DE PISO] Para quitar la boquilla de Piso, inserte un desarmador en el orificio y jale mientras que Seguro de presione el seguro de cierre. Cierre Orificio de Quitar de la Boquilla de Piso 2. Quite el recipiente de polvo y conecte el mango con la unidad principal. MANGO TUERCA 1 Coloque el mango en el PERNO 2 Inserte el perno y orificio de la unidad principal para fijarlo, como se muestra.
5. Encienda el interruptor. 1 Presione hacia abajo con su pie el pedal de liberación de mango y levante el mango hasta que libere de su posición derecha. (alrededor 30°, se cerrará. Presione hacia abajo de nuevo el pedal para mover para la posición paralela.) 2 Presione hacia abajo con su pie el pedal de pie de encendido y apagado (ON/OFF) para encender la unidad. Presione otra vez para apagarla. 2 Presione el pedal de encendido y apagado (ON/OFF.) 1 Presione el pedal de liberación de mango.
COMO USAR LOS ACCESSORIOS LIMPIEZA USANDO EL ACCESORIO PARA HENDIDURAS, EL TUBO DE EXTENSIÓN, Y EL CEPILLO PARA DESEMPOLVAR 1. Quite la manguera de la unidad principal. MANGUERA 2. Al insertar el accesorio para hendiduras, el tubo de extensión o el cepillo, inserte firmemente en el extremo de la manguera. Inserte firmemente el accesorio que desea en el extremo de la manguera. Después de usar, conecte el final de la manguera firmemente en la unidad principal.
VACIANDO EL RECIPIENTE DE POLVO PRECAUCIÓN Cuidadosamente vacíe la suciedad. Las partículas de polvo muy finas pueden sellar el filtro de rejilla y ocasionar una perdida de succión. También puede dañar el motor. • Siempre apague la aspiradora (OFF) cuando vacíe el recipiente de polvo. • Rebasando de la línea del amplio “Máximo” podría causar que polvo y residuo sellen el filtro y ocasionar que disminuya la succión.
MANTENIMIENTO Siempre apague la aspiradora y desenchufe el cable antes de darle servicio. UNIDAD PRINCIPAL • BOQUILLA DE PISO • MANGO • Limpie la suciedad de la aspiradora con un paño seco y suave. • Cuando la aspiradora se ensucie extremadamente, empape un paño suave en agua con una cantidad pequeña de detergente suave, y tuérzalo bien. Con el paño seco, enjuáguela hasta que esté limpia. • No use diluyente, bencina, o ningún otro tipo de limpiador de regador para limpiar la unidad.
GUÍA PARA LA DETECCION Y SOLUCION DE PROBLEMAS Si tiene dificultades con su aspiradora, utilice primero esta guía para la detección y solución de problemas antes de solicitar el servicio. PROBLEMA COMPROBACIÓN La aspiradora no enciende cuando el pedal de encendido y apagado esta en la posición de ON. ¿Está conectado el enchufe de potencia completamente en el tomacorriente? SOLUCIÓN POSIBLE Enchúfelo bien.
GARANTÍA GARANTÍA LIMITADA DEL ASPIRADORA DE POLVO SANYO OBLIGACIONES SC-TA3000 Con el fin de obtener el servicio de garantía, deberá enviarse e ir a buscar el producto a un Centro de Servicio de Fábrica Autorizado por Sanyo a cargo del usuario, a menos que se mencione lo contrario en esta garantía. Los nombres y direcciones de los Centros de Servicio Autorizados por Sanyo podrán obtenerse llamando a los números sin cargo que se enumeran a continuación.