User's Manual

BlueTone

BTHF102/202 User Manual

. 10

Turn off the Handsfree: Long press K1, you will hear 2 power-down tones, and All LEDs are off. This indicates

the handsfree is power off.

2.4 Pairing/Connecting your Handsfree with Bluetooth Equipment

2.4.1 Pairing your Handsfree with Bluetooth handset

Before making and answering calls, you must pair your handsfree and phone. Paring sets up a unique relationship

between your handsfree and your handset. The handset will memorize the handsfree’s unique ID (or passkey). This

ensures that a unique and encrypted wireless link between your handsfree and handset will be used during calls.

Detailed operation procedures are as follows:

1. Place your handsfree close to your Bluetooth handset, and ensure your handsfree is power off, your handset is

power on

2. Press and hold K1 for at least 6 seconds until the Blue and Red LEDs alternate continuously. You will hear 2

power-up tones and a pairing tone to indicate that the handsfree has successfully entered the paring mode

3. Following your phone user guide to active Bluetooth device search on the phone side, on your phone screen

you will see a list of Bluetooth equipment found by the phone at the end of the searching process.

4. Select this Bluetooth Handsfree from the list (for BlueTone

BTHF102 ,the sign is ’BTHF102’ , and for

BlueTone

BTHF202 the sign is ’BTHF202’）and initiate pairing following handset’s on-screen prompts.

5. Continue to follow on-screen prompts to enter passkey “0000”and confirm to pair the handsfree with your

handset. Once the pairing procedure is completed, you will hear a connecting tone, and then Blue LED gives 3

quick blinks per 2 seconds. This indicates that the handsfree device and the handset are paired and connected.

Note

：

1. If pairing is successful, handsfree’s Red LED is off. The Blue LED gives 3 quick blinks per 2 seconds. If paring

is failed

，

the Blue and Red LEDs alternate continuously (for about 2 minutes). You need to go back to above

steps 3-5 to repeat the paring process.

2. Your handsfree will remain in the pairing mode for about 2 minutes. If paring cannot be finished within 2

minutes, the handsfree will enter into the standby mode (without Bluetooth connection in this case). You need

to repeat the above steps 2-5 to restart the pairing process.

2.4.2 Pairing your Handsfree with Other Bluetooth Equipment

In addition to Bluetooth phone, your handsfree can also pair with other Bluetooth equipment for realizing short

distance wireless communications. Similar pairing procedures described in the previous Section can be used. You

can follow the user guide of the Bluetooth equipment to complete paring operations on the equipment side.

This handsfree can paired with up to 8 Bluetooth equipments (including mobile handsets). The corresponding 8 sets

of pairing information are recorded by the handsfree. Each paired equipment can wireless communicated with the

handsfree after setting up a Bluetooth connection. Please check Section 2.4.4 on procedures to set up a Bluetooth

connection.