User's Manual

BTHF341 User Manual
. 10
1. Place your handsfree close to your Bluetooth handset, and ensure your handsfree is power off, handset power
on.
2. Press and hold button
for at least 8 seconds until the Blue and Red LEDs alternate continuously. You will
hear 2 power-up tones to indicate that the handsfree has successfully entered the paring mode.
3. Following your phone user guide to activate Bluetooth device search on the phone side, on your phone screen
you will see a list of Bluetooth equipment found by the phone at the end of the searching process. Select this
Bluetooth handsfree from the list “BTHF341”, and initiate pairing following handset’s on-screen prompts.
4. Continue to follow on-screen prompts to enter passkey “0000”and confirm to pair the handsfree with your
handset. Once the pairing procedure is completed, you will hear 2 high tones, and then Blue LED gives 1quick
blink per 2 seconds. It indicates that the handsfree device and the handset are paired and connected.
Note
：
Your handsfree will remain in the pairing mode for about 2 minutes. If paring cannot be finished within 2 minutes,
the handsfree will enter into the standby mode (without Bluetooth connection in this case), and Blue and Red LEDs
will stop alternating continiously, with Blue LED blinking per 3 seconds instead. You need to turn the handsfree
off and then repeat the above steps 2-4 to restart the pairing process.
If you want to use the device with another mobile phone, you must repeat the pairing process again. You can also
follow the user guide of the Bluetooth equipment to complete paring operations on the equipment side.
BTHF341 could store up to 8 handset pairing information while only one of them could be connected each time.
Short-distance wireless communication could be realized with each handset if information stored and connected to
the handsfree.
2.4.2 Disconnecting your Handsfree with Bluetooth Equipment
When handsfree is currently connecting with Bluetooth handset (or in the connected mode), you can disconnect
them by:
1. Pressing and holding button
for at least 2 seconds.
2. Following the handset user guide and initiating disconnection from the handset side.
After disconnecting, you will hear a disconnecting tone, and then Blue LED gives 1 blink per 2 seconds.
2.4.3 Connecting your Handsfree with Bluetooth Equipment
If the device and the handset have been successfully paired and connected, to reconnect them after an unexpected
disconnection, you can either quick press handsfree’s call button
to initiate a connection request or follow the
handset’s user guide to find the handsfree and send a connection request from the handset.
When the connection is established, you will get 2 high tones and the Blue LED changes to 2 quick blinks per 2
seconds.
2.4.4 Delete Paired Records
This handsfree can store up to 8 Bluetooth equipments. When in the paring mode, pressing and holding ━ button
for at least 2 seconds will allow you to erase all paired Bluetooth device profiles stored in the handsfree.