User Guide
Table Of Contents
- Table of Contents
- Camera Installation
- 1.1 Warnings and Cautions
- 1.2 References
- 1.3 Installation Overview
- 1.4 Camera Connections
- 1.5 Concealed Cable Mount Accessory
- 1.6 Camera Specifications
- Basic Operation and Configuration
- Advanced Configuration
427-0089-00-12 Version 180 August 2020 19
This document does not contain any export-controlled information.
Camera Installation
Step 4 Install the wall mount (PN 4129742) to the
wall and pull the cable(s) through the mount.
Cut a small cross-slit in the black mount
gasket and push the cable(s) through the
gasket. Pull the cable(s) through the opening
in the bottom of the camera. A single Ethernet
cable is shown in the images.
Step 5 Secure the camera to the mount using four
M5 x 0.8 threaded fasteners to the bottom of
the camera. Use Loctite 222 low strength
thread locker for the mount fasteners.
Step 6 As needed, clean the o-ring and the o-ring
groove in the bottom of the camera using
isotropy alcohol and press the o-ring into its
groove.
Step 7 For each cable, punch a hole in the center of
a gland seal from the top using the 3 mm hex
key. Insert the cable from the bottom though
the hole.
Step 8 Place the gland plate back into position and
tighten the four 3 mm captive screws using a torque value of 1.8 n-m (16.0 in-lbs).
Step 9 Check the length of each cable to ensure an appropriate bend radius and terminate the
cable. Connect the cables as indicated in Camera Connections, pg. 13.
Step 10 Push the cable back through the gland seal so that the seal is extended down not up, as
shown in the illustration below.
Caution!
Step 11 Ensure that any ground wire that was removed during installation is reconnected. Replace
the cover and tighten the four 3 mm hex screws to 1.8 n-m (16.0 in-lbs).
Step 12 Using the hex key included with the concealed cable mount, loosen the ball joint on the
bottom of the mount, position the camera as required, and then re-tighten the ball joint.
When replacing the cover, make sure the ground wire between the cover and the camera body is
completely inside the o-ring groove. If the wire is pinched between the cover and the base, the
camera will not be sealed against water ingress and could be damaged.
Figure 1-15: Camera Mount
Mount Gasket
Figure 1-16: Cable through Seal Plate
Wrong
Correct