User Guide
Table Of Contents
- Table of Contents
- Camera Installation
- 1.1 Warnings and Cautions
- 1.2 References
- 1.3 Installation Overview
- 1.4 Camera Connections
- 1.5 Concealed Cable Mount Accessory
- 1.6 Camera Specifications
- Basic Operation and Configuration
- Advanced Configuration
427-0089-00-12 Version 180 August 2020 35
This document does not contain any export-controlled information.
Basic Operation and Configuration
To upload a self-signed or third-party CA signed certificate:
Step 1 For Method, select Upload
Certificates.
Step 2 If you are uploading a self-signed
certificate, under Upload Certificate,
browse for and upload the public key
file. Then, under Private Key, browse
for and upload the private key file.
If you are uploading a third-party CA
signed certificate, under Upload
Certificate, browse for and upload the
public key file. Under CA Certificate,
browse for and upload the CA
certificate file. Under Private Key,
browse for and upload the private key
file.
Step 3 Verify that the camera certificate files are valid. Make sure Certificates are OK appears
under Method.
Certificate information appears at the bottom of the TLS Config page, under Certificate
Information:
To enable and configure TLS:
Step 1 Under TLS Configuration, for Enabled, select
Yes.
Step 2 Select whether to redirect HTTP requests to
HTTPS.
Step 3 Click Save.
Step 4 Click Reboot. The camera reboots. After the camera reboots, TLS is enabled.