User Guide

427-0089-00-12 Version 180 August 2020 36
This document does not contain any export-controlled information.
Basic Operation and Configuration
SNMP Config Page: The setting on this page enables or
disables SNMP. (By default, SNMP is disabled.) With
SNMP enabled and the camera connected to or on the
same VLAN as the PC or other component submitting the
request, the camera responds to the following command
with the camera's uptime:
snmpwalk -v2c -c public <camera's IP address>
Server Status Page: The Server Status page provides an indication of the current server status
(either running or stopped) and buttons for starting or stopping the server or for rebooting the
system.
After making configuration changes, it is necessary to save the changes to the server (there is a
Save button at the bottom of each configuration page). The configuration changes do not take effect
immediately. Generally, it is also necessary to stop and restart the server for the changes to become
effective. The server has a configuration that is active and running, and another configuration that is
saved (and possibly different than the running configuration).
The message at the bottom of the page indicates the
saved configuration is different than the active (running)
configuration, and it is necessary to restart the server.
It may take up to 20 seconds or more to stop the server, especially when there are multiple video
streams open. Be patient when stopping the server.
When the server is stopped and the page is refreshed, the status will show Server Stopped and the
Start button will be enabled.
Click on the Start button to restart the server, and when the page refreshes, the status will again
show Server Running. The Start button will be replaced by a Stop button when the startup procedure
has completed.
Toggle Server (Stop/Start)