User Guide

427-0089-00-12 Version 180 August 2020 56
This document does not contain any export-controlled information.
Advanced Configuration
3.2.1 Sensor Menu
The configuration changes commonly used are done through the Sensor
menu. Described below are configuration steps from the Communications
and Modules selections.
Communications Menu
The primary IP configuration parameters, such as IP address, network
mask, and gateway, are configured with the LAN Settings page (refer to
LAN Settings Page, pg. 29). The Networking page can be used to configure
some of the other IP networking parameters.
Networking Page: Generally it is assumed the camera network will be
secured through recognized network security measures and best
practices, such as limited physical access, firewalls, and so on. As an
additional security consideration, it is possible to restrict access to the
camera to a limited number of IP Addresses.
It is possible to restrict access to the camera by remote clients by setting the “Allow Anonymous
Clients” to No, and then enter IP addresses for the clients that are allowed access in the Remote
Clients parameter.
The default TCP port for most FLIR IP cameras is 1001. This is the port number that a client program
such as FLIR Latitude can use to communicate with the camera. If using an ONVIF-compliant VMS
as a client, refer to VMS Remote, below.