User Guide
Table Of Contents
- Table of Contents
- Camera Installation
- 1.1 Warnings and Cautions
- 1.2 References
- 1.3 Installation Overview
- 1.4 Camera Connections
- 1.5 Concealed Cable Mount Accessory
- 1.6 Camera Specifications
- Basic Operation and Configuration
- Advanced Configuration
427-0089-00-12 Version 180 August 2020 65
This document does not contain any export-controlled information.
Advanced Configuration
For example, you can configure these OSD options for the Label when the Custom Text Mode is
selected:
The OSD text will appear on the IP video streams.
Alarm Manager Page: Use the Alarm Manager page to set the response (action) that results from
an individual alarm. It is possible to have more than one action for a single alarm by adding
additional rules (for example, one action could capture an image and another could generate an
output). If a message is to be sent from the camera as a result of an alarm, it is necessary to define
Message Systems and set up Notification Lists (refer to Services Menu, pg. 31).
In general, each Alarm Rule describes an alarm Source and a single alarm Action. For the
FC-Series ID camera, the source of the alarm typically will be internal from the video analytics,
although it is also possible for the camera to receive alarms from another camera or device/server
on the network (such as a radar server, input/output server, ground sensor, fence system, or other
security sensor).
Set Enable
to Yes