User Guide

This document does not contain any export-controlled information.
Installation
7
427-0200-00-12 - Revision 110 - May 2021
2.4 Mounting the Camera
The following accessories and adapters are available for mounting the camera:
· Wall Mount Bracket CX-ARMX-G3
· Wall Mount Bracket with Power Box CX-ELBX-G3
· Gooseneck Mount with Power Box CX-GSNK-G3
· Corner Adapter CX-CRNR-G3
· Pole Adapter CX-POLE-G3
2.4.1 Securing the Camera
When using either Wall Mount Bracket CX-ARMX-G3 or Wall Mount Bracket with Power Box CX-ELBX-
G3 with a Saros PTZ DM-Series camera, you need to secure the camera using a safety lanyard.
1. Before attaching the mounting accessory to the mounting
surface, attach the safety lanyard to a secure anchor point
on the mounting surface or on the accessory.
2. through the mounting accessory and through the pendant
cap.
3. Attach the lanyard to the safety ring on the camera.
4. Route the power, Ethernet, and other cables through the
mounting accessory and attach the mounting accessory to
the mounting surface.
5. Route the power, Ethernet, and other cables through the
pendant cap and attach the pendant cap to the mounting
accessory.
6. Connect the cables to the camera.
7. Carefully insert the camera into the pendant cap and rotate the camera until it locks into place (1/3
turn).
Warning:
The metal locking mechanism carries the weight of the camera. If the camera is not locked into
place, it could become loose and fall.
The screw that attaches the pendant cap to the camera needs to line up with one of the corresponding
screw holes on the camera.