User Guide

This document does not contain any export-controlled information.
Installation
16
427-0200-00-12 - Revision 110 - May 2021
2.5 Camera Connections
Connectors
Connector
Connection
1
DC12V IN
If using a 12 VDC power supply, connect its wires to the
two-pin power connector.
2
UPOE
Attach a Cat 5e or Cat 6 cable from the network switch to
the RJ45 connector for a 10/100/1000 Mbps Ethernet and
Universal PoE connection. If using Universal PoE, FLIR
recommends using a FLIR CP-POE-60W-xx or equivalent
power injector. Verify that the UPOE connector LEDs are
steady green and flashing yellow.
3
AC24V IN
If using a 24 VAC power supply or a heater, connect its
wires to the three-pin power connector.
4
DEFAULT
To reset factory defaults at any time, press the Default
button for at least 20 seconds.
5
14-pin terminal
block
Attach wires from external devices to the 14-pin terminal
block connector for alarm and audio in/out (see diagram
and definitions below).
14-Pin Terminal Block
Pin
Definition
Pin
Definition
1
Audio-Out
8
Not used
2
Ground (Audio I/O)
9
Alarm-In 4
3
Alarm-Out A1
10
Alarm-In 3
4
Alarm-Out A2
11
Alarm-In 2
5
Alarm-Out B1
12
Alarm-In 1
6
Alarm-Out B2
13
Ground (Alarm I/O)
7
Not used
14
Audio-In