User Guide

This document does not contain any export-controlled information.
Configuration
33
427-0200-00-12 - Revision 110 - May 2021
4 Configuration
Users assigned the admin or expert role can click System Settings on the View Settings page to
configure:
· Networking
· Date and time
· User accounts and passwords
· Audio parameters
· I/O devices
· ONVIF interface
In addition, you can use the Firmware & Info page to upgrade the camera's firmware, reset the camera to
its factory defaults, reboot the camera, and configure other parameters.
4.1 Network Page
When a user assigned the expert or admin role clicks System Settings, the Network page appears.
The IP address mode can be set to DHCP (default) or Static.
Define the camera's hostname, which identifies the camera.
When the IP address mode is Static, specify:
· IP—The camera's IP address
· Netmask—The default value is 255.255.255.0
· Gateway
When the IP address mode is set to DHCP, if a DHCP server is not available on the network, the
camera's default IP address is 192.168.0.250. For information about defining the camera's IP address
using the DNA tool, see Initial Networking Configuration.