User Guide

This document does not contain any export-controlled information.
Installation
20
427-0300-00-12 - Revision 110 - May 2021
2.7 Initial Configuration
You can configure the camera using the DNA tool, the camera's web page, or a VMS.
DNA tool
Camera's web page
Discover camera IP address
•
Configure IP address, mask, and gateway
•
•
Configure DNS settings, MTU, and Ethernet speed
•
Change user credentials
•
•
Configure more than one camera at the same time
•
Notes
· The DNA tool does not require a license to use and is a free download from the product's web page
on FLIR.com. For more information about using the DNA tool, including how to configure more than
one camera at the same time, see the DNA User Guide. While the software is open, click the Help
icon
.
· For more information about using a VMS to configure one or more cameras at the same time, see the
VMS documentation.
To configure the camera for the first time, do the following:
· Configure for Networking
· Install and Test the Optional Wash Kit
· Attach the Camera to a VMS
2.7.1 Configure for Networking
By default, DHCP is enabled on the camera and a DHCP server on the network assigns the camera an IP
address. For example, if the camera is managed by FLIR's Horizon or Meridian VMS and the VMS is
configured as a DHCP server, the VMS automatically assigns the camera an IP address.
If the camera is managed by FLIR’s Latitude VMS or is on a network with static IP addressing, you can
manually specify the camera’s IP address using the DNA tool or the camera's web page. The camera's
default IP address is 192.168.0.250.
To configure the camera for networking using the DNA tool:
1. Make sure the camera and the PC are on the same LAN segment.
2. Run the DNA tool (DNA.exe) by double-clicking . The Discover List appears, showing compatible
devices on the VLAN and their current IP addresses.