User Guide

This document does not contain any export-controlled information.
Installation
23
427-0300-00-12 - Revision 110 - May 2021
4. Tighten the delivery joint.
5. Unscrew the knurled nut (01) from
the delivery joint (02). Insert the
knurled nut on the delivery pipe
(03). Insert the end of the delivery
pipe into the spinner (04). Lock
the nut to the coupling.
6. Fasten the semi-rigid pipe and aim the nozzle towards the camera lens windows. Depending on how
and where you are installing the camera and the wash kit, you can use one of the nozzle support
brackets supplied with the wash kit to secure and aim the nozzle.
Important
When you test the wash kit, you will set the camera's washer position using the camera's web page.
Aim the washer nozzle so that it sprays liquid over both camera lens windows when the camera is in
what will be its washer position. Activating the camera's wiper when the lens windows are dry causes
irreparable damage to the window coatings and voids the camera's warranty.
Make sure the camera's I/O settings activate the washer pump
1. With a user assigned the admin or expert role, log in the camera's web page. For information about
how to log in to the camera's web page, see Accessing the Camera.
2. Open the I/O Devices Page.
3. Select local output 1.
4. Make sure the following local output 1 default settings are
specified:
Setting
Value
State
Off
Idle State
Open
Reset Interval
0 seconds (automatic output pin reset is
disabled)
Testing the washer and wiper
Before testing the washer and wiper, make sure you:
· Install the wash kit according to the kit's instructions manual and according to the instructions above.
· Fill the washer liquid tank.