User Guide

Table Of Contents

This document does not contain any export-controlled information.

Operation

427-0300-00-12 - Revision 110 - May 2021

Where relevant, changing the settings on the Thermal page immediately affects the live thermal video

images and stream. To save changes, click Save. To discard changes, click Reset and then Discard

Changes.

3.6 Input/Output (I/O) Page

Adjust local and external I/O settings on the I/O page.

For local I/O connections:

Input settings

Output settings

If an optional washer pump is connected to pins 3 and 4 (Alarm-Out A1 and A2) on the camera's 14-pin

terminal block connector, the washer controls on the Wiper Page activate it through local output 1. For

information about how to configure local output 1 to activate the washer pump, see Install and Test the

Optional Wash Kit.

For information about the local I/O connector, see Camera Connections.

For external I/O connections, set the current state

for the input and output pins, as shown at right.

You can configure the external I/O connections,

including the number of external input and output

pins, on the I/O Devices Page in System Settings.