User Guide

This document does not contain any export-controlled information.
Operation
40
427-0300-00-12 - Revision 110 - May 2021
· Installation Height, in meters above the ground (must be greater than zero)
· Orientation: the installation angle of the “zero-pan” line of the camera, between 0-360 degrees from
North
Preset positions are relative to the camera's orientation. Changing the orientation affects existing
presets. If any presets have been defined, after changing the camera's orientation, go to the PTZ Page
and redefine them.
After making any change on the Georeference page, click Save to save the changes.
The camera can report this georeference information via FLIR CGI/SDK or ONVIF, which:
· Allows the user or an application to:
o Show the camera on a map
o Show the direction the camera is facing (using the camera's field of view, which the camera also
reports)
· Supports pan and tilt cueing. For example, the FLIR CGI protocol provides pan and tilt commands to
point the camera at a specific geographic location (latitude/longitude).