User Guide

This document does not contain any export-controlled information.
Configuration
52
427-0300-00-12 - Revision 110 - May 2021
3. On your computer or network, browse to and select the firmware file.
Caution
Only upgrade to firmware developed for Elara DX-Series cameras.
4. Click Upgrade.
The camera uploads and installs the firmware, which takes a minute or two. After installing firmware, the
camera requires a reboot. When prompted, confirm rebooting the camera.
Factory Defaults
Click Full Reset to return the camera its original factory configuration.
Click Partial Reset to keep the current settings on the Network page and return all other settings to their
factory defaults.
Click Reboot to cause the camera to power cycle and reinstall configuration files.
Tip
You can also return the camera to its original factory configuration by pressing the camera's physical
Default button for at least 20 seconds; for example, if you are unable to access the camera via its web
page or other communication method. The Default button is located on the camera's connector panel.
Support System Info
Set the logging detail up to four levels; higher log levels increase the size of the log file.
Click Download to retrieve the camera's log files.
Other settings
For legacy VMS versions, enable the compatibility mode.