Brochure
UPGRADE YOUR MOISTURE METER
WITH FLIR ACCESSORIES
MR01 REPLACEABLE TEMPERATURE / RELATIVE HUMIDITY SENSOR
Designed for use with the FLIR MR77 or MR176 to take accurate temperature and humidity measurements. The MR01 is factory calibrated and features a protective cap. A metallic
screw secures the probe in place.
MR01-EXT TEMPERATURE / RELATIVE HUMIDITY SENSOR AND EXTENSION ASSEMBLY
Use for acclimation purposes, such as dryer/dehumidier exhaust vents and to extend the reach of moisture meter integral Temp/RH probes.
MR11 HANDHELD TEMPERATURE & HUMIDITY SENSOR ACCESSORY
Pre-deploy in dehumidier exhaust vents for instantaneous readings, or use in locations where access is restricted, such as small holes inside wall cavities.
MR04 EXTENSION POLE
Easily probe large and out-of-reach areas with this telescoping pole that extends up to 52 in. Or use to extend the reach of the MR77 or MR176 relative humidity/temperature probe;
for example, access inside of wall cavities.
MR05* IMPACT PROBE
Easily test for moisture in challenging spots – on rough or uneven surfaces, in corners, in hard woods or high-density materials, and in areas without a dry reference.
MR06* WALL CAVITY PROBE
Penetrate into wall cavities and the inside face of exterior walls to measure insulation moisture levels.
MR07 HAMMER PROBE
Take measurements in suboor through carpet, hardwood ooring, and hard materials that are difcult to penetrate with a standard pin probe.
MR08 HAMMER / WALL PROBE
Comfortably hammer probe into vertical, angled, or inverted surfaces, and get down below carpet pads and suboor.
MR09 BASEBOARD PROBE
Probe behind baseboards, wall trim, crown molding, and other inaccessible areas without requiring removal.
MR10 PROTECTIVE CASE
Safeguard your valuable FLIR T&M instruments with this durable EVA protective case to shield against dirt, dings, and harsh environmental conditions.
MR12 BALL PROBE MOISTURE SENSOR ACCESSORY
Take non-invasive readings up to 100 mm (4 in) below a surface.
*FLIR recommends using the MR05 or MR06 to test moisture in concrete/building materials. Please review your instruction manual for complete details.
MOISTURE METER
ACCESSORY COMPATIBILITY
Accessory / Moisture Meter MR40 MR55 MR59 MR60 MR77 MR160 MR176
MR01 Temperature / Relative Humidity Sensor - - - - x - x
MR01-EXT Temperature / Humidity Sensor with Extension - - - - x - x
MR11 Handheld Temperature / Humidity Sensor - - - - x - x
MR02 Pin Probe (spare) - - - x x x x
MR04 Extension Pole - - x - - - -
MR05 Impact Pin Probe - - - x x x x
MR06 Wall Cavity Probe - - - x x x x
MR07 Hammer Probe (with bag) - - - x x x x
MR08 Hammer and Wall Cavity Probe Combo (with bag) - - - x x x x
MR09 Baseboard Probe - - - x x x x
MR10 EVA Protective Case - - - x x x x
MR12 Ball-Type Moisture Sensor - - - x - x x
MR01 MR11 MR04 MR05 MR06
MR07 MR08 MR09 MR10 MR12