Datasheet

5 Operation
5.1 Basic operation
1. Insert an SD card into the SD card slot, located on the bottom of the monitor.
2. Connect the probe to the monitor or turn on the wireless adapter if applicable.
3. Press and hold down the
button for 5 seconds to switch on the
monitor.
4. If the battery indicator
shows that the battery voltage is low or if the
monitor does not power on, recharge the battery. See section 6.2 Battery re-
charging, page 21.
5. Maneuver the probe into position to view the area to be examined. The probe
can be bent into the shape of the area to be examined. The optimum focus
distance is probe dependent.
6. For TWO-CAMERA PROBE, press the
button to toggle between the
side view and the front view camera lens. Two-camera operation requires a
direct connection of the dual channel cable (VSC2-58-1FM) to the VS70
monitor.
7. Use the
and buttons to zoom in and out.
5.1.1 Controlling the camera LED light intensity
Note The camera LEDs become warm when set to maximum intensity.
1. In wireless mode, use the light intensity buttons on the articulating probe
(see Figure 4.4 Articulating probe, page 9) or wireless transmitter (see Fig-
ure 4.5 Wireless transmitter, page 10) to increase/decrease the light intensity.
2. In direct mode, use the
and buttons to increase/decrease the
light intensity.
5.1.2 Taking a picture
1. Press the
button to take a picture and store it in the memory. The
icon is briefly displayed.
5.1.3 Recording a video
1. Audio can be recorded on the video via the microphone, located on the bot-
tom of the monitor. For audio recording, remove the bottom access cover.
#T559827; r. AE/36943/36943; en-US 12