Datasheet

5 Operation
Note The articulating probe battery must be fully charged for wireless opera-
tion. A weak battery may result in shut down of data transmission.
Note The FLIR VS70 wireless operation transmits on 2.4 GHz which may inter-
fere with other equipment operating on this same frequency.
1. Connect the AC adaptor to the articulating probe and charge the battery if
necessary.
2. On the monitor, press and hold down the
button for 5 seconds to
switch on the monitor.
3. In the setup menu under INPUT SOURCE, select WIRELESS. Refer to sec-
tion 5.2 Setup menu, page 13.
4. On the articulating probe, press and hold down the
button for 5 sec-
onds to switch on the articulating probe. The camera video is displayed on
the monitor display.
5. Insert the probe into the area to be examined. Adjust the camera tip to the re-
quired viewing angle.
5.5.2 Articulating probe—direct version
1. Connect the articulating probe to the probe connector on the monitor, using
the supplied patch cable.
#T559827; r. AE/36943/36943; en-US 16