Datasheet

5 Operation
2. On the monitor, press and hold press and hold down the
button for 5
seconds to switch on the monitor. The camera video is displayed on the
monitor display.
3. In the setup menu under INPUT SOURCE, select DIRECT. Refer to section
5.2 Setup menu, page 13.
4. Insert the probe into the area to be examined. Adjust the camera tip to the re-
quired viewing angle.
5.6 Wireless transmitter
The wireless transmitter is intended for use in areas that are difficult to access or
in situations where it is hard to maneuver the probe with the display attached.
The wireless transmitter can also be connected directly to the monitor using the
patch cord.
5.6.1 Wireless transmitter—wireless version
Note The wireless transmitter battery must be fully charged for wireless opera-
tion. A weak battery may result in shut down of the transmitter.
Note The FLIR VS70 wireless operation transmits on 2.4 GHz which may inter-
fere with other equipment operating on this same frequency.
1. Connect the AC adaptor to the wireless transmitter and charge the battery.
2. Attach the probe to the wireless transmitter.
#T559827; r. AE/36943/36943; en-US 17