FAQ

Frequently Asked Questions | 3
faqs
Replacing tiles to fit perfectly back in place?
When it’s time to peel up a tile to either clean or replace it, just keep in mind the direction of the arrows from your original
install and ensure you place the tile back with arrows going the same direction. Depending on the tile type, it might be a snug
fit to place the tile back in place. Simply peel back the edges of the adjacent tiles as you slide the new tile back in place for a
perfect fit.
Struggling with a tricky cut?
CUTTING AROUND A VENT
Remove the vent plate and place the tile, fiber facing up, over the open vent. Once the tile is in position and lined up with the
adjacent tiles, cut through the vent with your carpet knife. Cut out the vent with the fibers up. It can be a little smaller than the
actual vent opening. Your vent plate will help hide any imperfections.
CUTTING AROUND A CORNER
When it’s time to cut up against the corner, flip your tile over, fibers facing down, toward the floor. Mark your tile just like you
would up against the wall. Use your carpet knife to mark where the tile needs to be cut, then cut from the back.
Not finding your answer?
Visit floorigami.com and chat now,
or call us and speak with a Floorigami
expert at 1-844-742-7429.
still stuck?