Product Brochure

72
Installation
Please email Tile Council of America if you have a technical question related to the
underlayment, use of setting materials, or other installation related question. You can
reach them at [e-mail] or you can view the TCNA Installation Handbook
at http://www.tileusa.com/publication_main.htm.
Before tile installation begins, the installer is responsible for checking the tile for obvious
visual defects. Cartons and pallets of tile must be blended to achieve an aesthetic blend.
No claims will be accepted after installations which have obvious visual defective tile.
Substrate surfaces shall not show variations in excess of:
Wall Floor
Dry-Set Mortar 1/8” in 8’ 1/8” in 10’
Organic Adhesive 1/8” in 8’ 1/16” in 3’
Latex-Portland Cement Mortar 1/8” in 8’ 1/8” in 10’
Epoxy 1/16” in 3’ ANSI
Installation Standard:
Comply with applicable parts of ANSI A-108 Series for ceramic tile installation. Extend tile
work into recesses, and under and behind equipment and fixtures except where otherwise
shown. Fit tile to electrical outlets, piping, fixtures and other penetrations so that plates,
collars or covers overlap tile. Joints shall align vertically and horizontally between trim and
field tile. Grout tile to comply with reference installation standards using grout materials
indicated.
Protection:
Leave finished installation free of cracked, chipped, broken, unbonded or otherwise
defective tile work. Protect all floor tile installations with kraft paper or other heavy
covering during construction period to prevent staining or damage. No foot or wheel traffic
permitted on floor for at least 7 days after grouting. Due to inherent size variation in porcelain
and ceramic floor tiles, a grout joint must be used. Your installer will be able to recommend a
suitable grout joint for the product you’ve selected.
Offset Installations (Brick Patterns):
The TCNA Handbook recommends no more than a 33% offset and a wider grout joint for
offset installations of tile larger than 18” on the longest side. This is because all tiles are higher
in the middle than at the edges. When the highest point (middle) of one tile is next to the
lowest point (edge) of the tile next to it, unacceptable lippage can result. Florida Tile is aware
that many installers wish to use tiles (especially 12”x24” tiles) in brick patterns with a 50% offset.
Typically our tiles are flatter than those of our competitors and better suited for this type of
application. We do recommend a wider (3/16” minimum) grout joint for this type of installation
and it is important to avoid ‘wash’ lighting that is set close to the tiled surface which can
aggravate the appearance of lippage due to shadows. Our 6x24 and wall tile products can be
installed with a typical 1/8” grout joint and a 50% offset. Care must be taken to follow the
subfloor flatness and installation guidelines in the TCNA Handbook for a successful installation.