Instructions / Assembly

Pumpkin Chair FHPC100 Assembly Instructions
1. Open the package
and unwrap the four
short legs and put
rubber feet on each of
the four legs
2. Bolt the four legs
to the X-frame base
of the Egg Chair
Stand
3. Put nuts and bolts
in middle of C frame
stand
4. Open chair frame
completely and put the
four catch pins in place
Make sure the flat tops
are on the inside of the
chair so they do not
poke through the fabric
or through the seat
5. Put the longer of the
two swivel pins in the
top of the C frame
stand
7. Attach seat spring to
swivel pin
8. Put the shorter of the
two swivel pins through
the top of the chair and
through the grommet,
then attach
10. Make sure all
fasteners are tight in the
seat frame is straight,
adjust your pillows the
way you like put in a
good level location and
enjoy your egg chair,
thank you for your
business
*US and foreign patents pending
6. Attach snap hooks to
each end of both sets of
chains, then slide one of
each and a washer on the
top swivel pin
9. Once the chair is
attached, tilt the chair to
either side. Clip the
snap hooks to the metal
loops on the chair,
repeat on both sides