Instructions

DSX-600 Series CableAnalyzer
Users Manual
92
The cloud icon shows that the project is only in LinkWare
Live and has not been synced to the tester.
The cloud and “+” icon shows that the project in LinkWare
Live has been synced to the tester, so you can use the project on
the tester.
Note
If you rename a synced project on the tester or in
LinkWare Live, and the project has the Active
status in LinkWare Live, the SYNC PROJECTS
screen on the tester shows both names in the
format DSX-600/602 Project Name -> LinkWare
Live Project Name. After you sync, the project’s
name on the tester changes to the name used in
LinkWare Live.
 Tap to collapse or expand the list of projects.
 If you select Assigned to me, you will see only projects that are
assigned to you in the project settings in LinkWare Live.
 The asset management icon shows when the owner of a
LinkWare Live account has enabled the asset management
service for the tester. See “About the Asset Management
Service” on page 93.
When You Cannot Sync a Deleted Project
When you delete a project in LinkWare Live, it goes into the
recycle bin. If you synced the project before it was deleted, then
try to sync it again, the tester shows a message to tell you that
you cannot sync a deleted project. You will see this message even
if you rename the project on the tester because LinkWare Live
gives each project a unique, hidden ID that never changes, and
uses this ID to identify projects. If it is necessary to sync the
project, go to the LinkWare Live recycle bin and restore the
project.